Wing - Left Flaps and Ailerons
Finished deburring all of the aileron brackets, the flap brace, and the aileron gap fairings. Then I primed all of the parts. I did things a little differently today. Normally, I would use Scotchbrite to scuff everything, clean all of the parts with solvent, and then etch them before priming. Today, I decided to use Dawn instead of solvent to clean the parts, and I didn't etch them. The etching is a major pain. This seemed to work ok.
 | All deburred. |
 | Primed the brackets using the special raised mesh flooring (chicken wire). |
 | Primed the flap brace and aileron gap fairing in my special primer booth (cardboard box). It was extremely humid today. Good thing this primer is waterborne. |