Wing - Left Wing

2004-07-17 - Riveting bottom skins. (2.0 Hrs).

The last rivets were a piece of cake. Everything went really well. The left wing is done (except for the wing tips)!

Left wing is done!

Here's the gap between the leading-edge and the rear skin. I think the camera angle distorts this a little, because it's really not that bad..

Here's a ding that I have been dying to clean-up. You can still see a small line, but it seemed to sand-out pretty good. I have a few others to do.

You can see a few dings where the rivets were poorly-driven. I should try the same camera angle on the top of the wing.

I am really happy with the gap where the two skins overlap. I really like that Cleveland edge roller.

	Left wing is done!
	Here's the gap between the leading-edge and the rear skin. I think the camera angle distorts this a little, because it's really not that bad..
	Here's a ding that I have been dying to clean-up. You can still see a small line, but it seemed to sand-out pretty good. I have a few others to do.
	You can see a few dings where the rivets were poorly-driven. I should try the same camera angle on the top of the wing.
	I am really happy with the gap where the two skins overlap. I really like that Cleveland edge roller.