Wing - Right Fuel Tank

2004-08-26 - Preparing the right fuel tank (access cover). (1.5 Hrs).

Cut out the hole for the T-408 access cover, and drilled the T-407 stiffener ring.

This setup is a lot better than with my first tank. I added a plywood table to the drill, so I could clamp the part down better. Notice one side sticking up. After removing the rib I realized that it cut one side more than the other because the table was not level. After leveling the table, the whole hole cut out just fine.

Drilled the T-405 attach angle and the T-407 stiffener.

	This setup is a lot better than with my first tank. I added a plywood table to the drill, so I could clamp the part down better. Notice one side sticking up. After removing the rib I realized that it cut one side more than the other because the table was not level. After leveling the table, the whole hole cut out just fine.
	Drilled the T-405 attach angle and the T-407 stiffener.