Wing - Right Wing
Continued doing preparation for assembling the wing skins and the leading edge. I did the nutplates on the W423 splice plate, deburred all of the wing skins, including the bottoms, and used the soldering iron to remove the plastic along the rivet lines.
A fellow builder asked me why I still keep the plastic on, since I am going to get scratches in the skins when I sand them for painting. I actually believe that the plastic will help prevent a deep scratch, and I just feel that it offers a small level of protection. Plus, I just like to do this, even though it is very time consuming. It may be a big waste of time, since some builders have reported corrosion under the plastic (hard to believe), and, supposedly, it is hard to remove the plastic after a month. However, I have had the wings for almost a year, and I had to remove the plastic on the inside of the leading edge skins. It did not seem any harder than on the empennage, which was a four month project. Then, again, I could be wrong.