Fuselage - AFT Section

2005-07-30 - Debur AFT Fuselage Assembly. (4.5 Hrs).

I finished deburring and dimpling most of the AFT fuselage parts, including the bottom and one side skin.

Bottom is deburred. There are about 100 holes along each side.

Dufus showed-up again to check on the project, and get his picture taken for the FAA. I don't see why he is so set on getting that Repairman's certificate. He can hardly turn a wrench. Look at how he is holding that screwdriver. How is he going to do an annual condition inspection?

Left side skin, all deburred.

I used the edge seamer on the bottom edge. The fuse skins are pretty thick, but you just need a little bit of an edge. You need to do this before you dimple. I usually forget.

Left side, deburred, and dimpled.

Bottom is deburred, and dimpled.

	Bottom is deburred. There are about 100 holes along each side.
	Dufus showed-up again to check on the project, and get his picture taken for the FAA. I don't see why he is so set on getting that Repairman's certificate. He can hardly turn a wrench. Look at how he is holding that screwdriver. How is he going to do an annual condition inspection?
	Left side skin, all deburred.
	I used the edge seamer on the bottom edge. The fuse skins are pretty thick, but you just need a little bit of an edge. You need to do this before you dimple. I usually forget.
	Left side, deburred, and dimpled.
	Bottom is deburred, and dimpled.