Fuselage - Center Section

2005-09-04 - Preparing the center Fuselage. (4.0 Hrs).

I fixed yesterday's screw-up, and did some more deburring and fluting on the seat ribs.

Fix for the mis-drilled snap bushing holes in the F-706 bulkhead. First, I cut the rib as deep as feasible.

Then, I clecoed the rib to F-706, and drew a circle where the snap bushing needs to go through F-706.

Problem solved.

The hole in F-706 is not pretty, but it will do. Maybe I should call my "Mistakes" section the "It will do" section.

A few of the seat ribs needed a little fluting. Actually, I had to flute all of them.

Four ribs, deburred, fluted, and dimpled.

	Fix for the mis-drilled snap bushing holes in the F-706 bulkhead. First, I cut the rib as deep as feasible.
	Then, I clecoed the rib to F-706, and drew a circle where the snap bushing needs to go through F-706.
	Problem solved.
	The hole in F-706 is not pretty, but it will do. Maybe I should call my "Mistakes" section the "It will do" section.
	A few of the seat ribs needed a little fluting. Actually, I had to flute all of them.
	Four ribs, deburred, fluted, and dimpled.