Fuselage - Forward Section

2006-02-26 - Preparing to rivet the side skins - step prep. (4.0 Hrs).

Cleaned-up the steps, added some SuperFil, and installed a few platenuts.

Filed-down and sanded the welds on the steps, and mixed-up some SuperFil to smooth the joints a little. This is way more than I need.

I told you it was way too much. I'll sand these down when this dries.

Pulled the skins off again, hopefully for the last time. Needed to debur the holes for the steps. Note, that if you install the steps, those 3 holes on F-724 did not need to be dimpled.

Doesn't look like much--steps filed, a few parts deburred, a few nutplates installed.

	Filed-down and sanded the welds on the steps, and mixed-up some SuperFil to smooth the joints a little. This is way more than I need.
	I told you it was way too much. I'll sand these down when this dries.
	Pulled the skins off again, hopefully for the last time. Needed to debur the holes for the steps. Note, that if you install the steps, those 3 holes on F-724 did not need to be dimpled.
	Doesn't look like much--steps filed, a few parts deburred, a few nutplates installed.